Professionally made program-controlled device with motor active braking, designed for airsoft electric guns (AEG). It adds new ways of shooting, controls rate of fire, pre-cocking, active braking and low battery indication. Device is fully integrated inside the gearbox version 3 instead of the original trigger contacts, compatible with Tokyo Marui standard.
Main parameters: - Easy installation inside the Gearbox version 2 - It preserves trigger mechanical lock in SAFE position - Six new shooting modes, one of them is unique compared processor units located outside gearbox - Adjustable burst (from factory are 3 shots, it can be changed in the range 1 - 10 shots) - Smooth change rate of fire using PWM motor control - Pre-cocking function for instant shot in SEMI fire - Quick first shot at reduced rate of fire - Mosfet with motor active braking - Adjustable strength of active braking (can be also disabled) - Low battery indication 2S and 3S Li-pol, 3S li-fe and 3S li-on - Monitoring current, voltage and temperature of Processor unit components - Trigger gun is used for programming this device, motor vibrates as a feedback for user - Programmed settings are stored in processor unit memory, so it doesn't loose changes after disconnection the battery
Fire modes: - Safe - Semi – Auto (unchanged gun function) - Safe - Semi - Burst/Auto - Safe - Semi - Semi - Safe - Semi - Burst - Safe - Semi - Semi (delay between shots, motor vibration when it is ready to fire) - Safe - Burst - Burst/Auto - Safe - Semi/Burst - Burst/Auto (unique fire mode only in this drop-in processor unit)
Specifications: - Only for electric airsoft guns with gearbox version 2 with switch designed according the Tokyo Marui company. - Devices without wires, you can use max. 1,5qmm (AWG16) power wires and 0,25qmm (AWG21) signal wires - If you are not familiar with soldering to the circuit board, choose device with wiring. - Designed for spring M180 and ROF 25bb/s. For higher load please use Extreme processor unit (it is outside gearbox) - For right function is necessary to have a functional gearbox cut off lever, selector plate, reverse latch, trigger and trigger block, as it has the standard gearbox - Specified for common batteries up to 14V (Ni-xx 8.4 - 12V, lipol 7.4 - 11.1V) - Current device consumption only 4.5 mA in idle state - Device increases gun rate of fire and battery holds longer, than with basic wiring - With active braking in semi fire mode piston isn't partially stretched, spring is fully released, parts in mechabox aren't under strain and nozzle locks hop-up chamber in greater part (depends on ROF) - In weapons with very high rate of fire (ROF) active break solves multiple shots in semi mode - The braking effect is the most powerful with high torque motor - In auto fire mode piston stops in random position due the mechabox design. But it stops much faster with active brake