- professionally designed and manufactured mosfet with motor active braking with 500mm long wires on each side for airsoft electric guns (AEG)
- four high quality 1,5qmm (AWG16) power wires covered with silicon insulation and two 0,25qmm (AWG24) signal wires
- If you want to use your own wires, choose device without wiring.
- Active break uses the excess energy from the motor to stop it. The braking effect is the most powerful with high torgue motor
- device has voltage stabilization for switch mosfet, mosfet is fully opened and makes less heat 
- in weapons with very high rate of fire (ROF) active brake solves multiple shots in semi mode
- in semi fire mode piston isn't partially stretched, spring is fully released, parts in mechabox aren't under strain and nozzle locks hop-up chamber in greater part (depends on ROF)
- in auto fire mode piston stops in random position due the mechabox design. But this stopping is much faster with active brake
- Active brake increases gun rate of fire and battery holds longer
- no sparking on switch contacts
- specified for common batteries: Ni-xx 8.4 - 12V, lipol 7.4 - 11.1V
- designed for maximum spring M150 and ROF 25bb/s. For higher load use extreme variant of this device
- easy to understand 6 wires connection
- device size 45x15x10mm
- coated with lacquer, which protects device against water
- in package is heat shrink over device and installation manual in English, which you can see here [PDF, 218.26 kB]

€ 27,90


Status:

IN STOCK

Delivery:
Order and pay today, delivery next business-day.
DPD: please order before 13h ; BPOST: order before 16h.
Quantity:
Add to cart